Turbo help needed my friends!
Hey guys I need your help again, Well im getting my dump pipe made today and I need to figure out somthing that has to do with the oil drain, now I need it to point streight down however I cant seem to undo all 6 bolts holf the compressor housing to the hotside, now is there a special tool I could use to get this, the reason I ask is because one of the hotside bolts is right behind the oil drain flang and its a really tight space!
|
cum on cum oN ,I need a lil advice!
|
A regular open faced wrench should work. Should be 13mm or 12mm bolts. Free the 2 bolts you can, then loosen the remaning 2 as much as you can. You should then be able to rotate the bearing housing enough at that point to remove them completely.
|
thanks again braineack , your help is appreciated!
|
Originally Posted by RicanmiataRacer
(Post 47213)
cum on cum oN ,I need a lil advice!
|
Just get an old open end, bend it as desired, and then cut it. You will use it over and over. Maybe.
|
All times are GMT -4. The time now is 09:01 AM. |
© 2024 MH Sub I, LLC dba Internet Brands