PNP STi Injectors??
10-04-2007, 04:29 PM
#1
Junior Member
Thread Starter
Join Date: May 2007
Location: Mountain View, CA
Posts: 220
Total Cats: 0
PNP STi Injectors??
Why is it that the #3910 STi injectors are not on the list for PNP any more. I just bought some and tried to install them and they are too short. Thin and pink but dont work. I looked on the list and they were recently removed, why is that??
Reply
0
0
10-04-2007, 04:52 PM
#5
Junior Member
Thread Starter
Join Date: May 2007
Location: Mountain View, CA
Posts: 220
Total Cats: 0
Yeah, I found out the hard way....bought them the night before got to the track yesterday, pulled my car apart and.......AHHHHHH TOOO SHORT. Damn.....not a good morning.
Reply
0
0
10-04-2007, 05:21 PM
#10
Boost Czar
iTrader: (62)
Join Date: May 2005
Location: Chantilly, VA
Posts: 79,493
Total Cats: 4,080
if they aren't on the list they are running RC injectors. sorry about the screw up, i was under the impression they were the same dimensions as the thin miata injectors....
Reply
0
0
, i've seen them go for $100+shipping before, you need to put those on a subaru forum or something...no one here will give you that much for them...$150 shipped maybe...
10-05-2007, 11:18 PM
#16
If they're too short can't you just remove the plastic rail spacers and run washers? I remember breaking some of the spacers and replacing them with washers. Or are the injectors still too short when you remove the rail spacers? Been a while since I messed with/installed injectors in a Miata. Like 6 years.
Frank
Frank
Reply
0
0
10-06-2007, 12:13 AM
#17
Junior Member
Thread Starter
Join Date: May 2007
Location: Mountain View, CA
Posts: 220
Total Cats: 0
I looked at that and the tip of it does not fit snug in the rubber grommet either. The length may work, probroably short, but I dont want to risk a big fuel leak....unless someone else has done it??
Reply
0
0
Thread
Thread Starter
Forum
Replies
Last Post
