xveganxcowboyx |
03-27-2013 12:37 AM |
Used Greddy kit - No vacuum
So I picked up a used Greddy kit last summer and am finally installing it. I have everything bolted up to test out the mechanicals before I do anything with fuel or tuning and have run in to a snag. I have no vacuum. At least not from the turbo. If I disconnect the intercooler piping and the gauge off the throttle body I get plenty, but I get nothing from the turbo end with everything hooked up. Nothing. Not a wiggle on the gauge.
I am wondering if the turbo could be crap and causing a huge restriction? It does spin, though with a low idle it did stop spinning once, but a blip of the throttle had it twirling ok. No serious shaft play (once it was oiled up....). I disconnected the intercooler hose and revved to about 3K and thought the flow seemed weak, but that is very subjective.......
Other factors: The manifold was cracked. I welded it. I doubt it will hold long, but I don't think it's leaking yet. Plenty of flow from the exhaust. Some small boost leaks still, but no gaping holes. Good airflow through the intercooler and all piping.
*edit* I put this in DIY, because A: this kit is fairly modified (intercooler, EMB, BOV) B: It's well used which is almost as complicated as DIY and C: If things are broken beyond repair I will be looking for advice on DIY, which should have been my route to start with.
|