What is the maximum gay you can have?
 

Gay being not straight. :ky:

Ok I pulled my manifold and trubo off and am checking to see if I need to get it machined. What do you guys think? Personally I think if I can see light through a straight edge it needs it, but I'm not sure if it would seal up once it gets warm.

https://www.miataturbo.net/attachmen...ine=1400678465

https://www.miataturbo.net/attachmen...ine=1400678465

https://www.miataturbo.net/attachmen...ine=1400678465

https://www.miataturbo.net/attachmen...ine=1400678465




Also, where on this manifold do I need to make my relief cuts? Between 1-2 2-3 3-4 or just 1-2 3-4?



https://www.miataturbo.net/attachmen...ine=1400678465


Thanks!

That's pretty maximum.

Machine it.

What he said.

Cutting between 1&2 and 3&4 worked for me, although 2&3 wouldn't hurt.

Definitely machine it flat.

Definitely gay.

Thanks you gays!

This thread is too gay for me.

https://www.miataturbo.net/attachmen...ine=1400681317

I think it was Savington or Turbo Tim who, when asked about the tolerances for the manifold to turbo surface, said .00 was flat.

https://www.miataturbo.net/attachmen...n-freefall-jpg

This is probably pushing the limit.

So I found out my straight edge wasn't so straight, which one of you got a hold of it? Waiting to get one that hasn't been tarnished.

Glad you found out before you were trapped in a marriage with a buncha kids.