Wiring Resistors up to Yellow Top injectors? WTF!?!
 

So a little while ago I got these....
http://i70.photobucket.com/albums/i1...6/SP_A0273.jpg
Supra yellow tops, low impedance flavour.....

and this came with them...
http://i70.photobucket.com/albums/i1...6/SP_A0274.jpg
Resistor pack to correct for the low impedance injectors.


My question is... how do I connect the resistor pack up to the injectors?
Anyone used something like this before?

I take it the yellow wire to the "Box" will be 12v+ supply, then the 4 red wires will go one to each injector?
Which wire on the pigtail should I be connecting to? I'm using the existing pigtails (I modified the tabs on the new injectors), and there is a red/coloured wire, and a white wire.

Is there a wiring diagram for the injector circuit?

I would use a multimeter to test, but my cars been sat for so long the battery is dead:mad:

http://honda-tech.com/zerothread?id=216710%20

Looks like you have a CRX resistor pack? (I've owned a couple of those cars ;))

Look at the 2nd post, 2nd diagram in the link. I've wired up a few hondas but never on the miata, but I would imagine it is the exact same principle.