1.6 GReddy at 11psi - 224hp/183tq
#1
Junior Member
Thread Starter
iTrader: (1)
Join Date: Jan 2009
Location: Bradenton, FL
Posts: 290
Total Cats: 5
1.6 GReddy at 11psi - 224hp/183tq
Finally got it dynoed. Here is the run down:
Stock 1.6 engine
GReddy 15G
GReddy manifold
Full 3" mandrel stainless exhaust w/ one Magnaflow muffler
Custom intake manifold w/ 4" plenum
CXRacing Intercooler kit
GReddy Type-S
RC 550cc injectors
Stock fuel pump and rail
MSPNP
Toyota COP's
BKR7E's @ .028"
DIY MBC
As you can see the intake manifold and 3" exhaust really wake this up on the upper end. The shop was a meager 94* according to the dyno, note 100* MAT. I was getting 175kpa (11ish psi) due to using a MBC and it being so damn hot. I was going to turn it up to compensate but decided against it. Please critique as you wish. I didn't touch the tune at all on the dyno. I have since added a smidge more accel to help that lean spike on tip in you see. All in all more then I was hoping for.
Also see my intro/biuld thread HERE
Discuss.
Stock 1.6 engine
GReddy 15G
GReddy manifold
Full 3" mandrel stainless exhaust w/ one Magnaflow muffler
Custom intake manifold w/ 4" plenum
CXRacing Intercooler kit
GReddy Type-S
RC 550cc injectors
Stock fuel pump and rail
MSPNP
Toyota COP's
BKR7E's @ .028"
DIY MBC
As you can see the intake manifold and 3" exhaust really wake this up on the upper end. The shop was a meager 94* according to the dyno, note 100* MAT. I was getting 175kpa (11ish psi) due to using a MBC and it being so damn hot. I was going to turn it up to compensate but decided against it. Please critique as you wish. I didn't touch the tune at all on the dyno. I have since added a smidge more accel to help that lean spike on tip in you see. All in all more then I was hoping for.
Also see my intro/biuld thread HERE
Discuss.
Last edited by Sokool; 08-23-2010 at 05:12 PM.
#15
Junior Member
Thread Starter
iTrader: (1)
Join Date: Jan 2009
Location: Bradenton, FL
Posts: 290
Total Cats: 5
The operator let off when the tach hit 7000. My log says 6927, dyno says 6700. I'll make him bounce the limiter next go. It's set to 7200...
Maybe I'll bump it to 13psi for giggles too.
Maybe I'll bump it to 13psi for giggles too.
#20
Elite Member
iTrader: (8)
Join Date: Dec 2008
Location: Kingston, Ontario
Posts: 2,910
Total Cats: 51
what specs did you use for that intake manifold if you dont mind?
are there velocity stacks in there?
I am essentially looking to replicate this IM...
A program to build these in theory would be amazing.
are there velocity stacks in there?
I am essentially looking to replicate this IM...
A program to build these in theory would be amazing.