Am I missing something? EMB
 

Hi guys, I’m sure someone can help?

Using the support tool software changes in the additional injection map or ignition map are present for aiflow meter v, pressure voltage, throttle position, all possible inputs. I only want to change parameters with pressure sensor input, not for throttle position etc. Am I missing something? Thanks Mark

What firmware do you have installed on the EMB? I just checked, and greddy pressure sensor is an option on mine, or relative pressure (kPa).... Although I have it setup differently with the olderguy clamp/autotune.

Might want to upgrade to 1.49.

Dave,

Hi firmware is 1.49, take additional injection map for example, the fuel values I have added in the map for "GReedy Sensor (V)" are still in the map window when I change the tab to "Throttle Possition %". I do not want to add fuel in both maps or not in the same places??

I'm not sure I understand what you are trying....

However, if you look at the additional injector map, you have the drop down at the top.... greddy sensor, tps, etc.....

That changes the vertical scale information, not the maps. It's one map, just change what you are "scaling" against the rpm.....

Dave,

OK, so I can only add additional fuel in one map based against one sensor input, there is only one map and you just chose your one input? (the same for ignition map).

So if I select presure sensor v, make my changes in that map it will not change the other non selected tabs at that map location?

Can you please confirm?

Its a shame there is not a seperate fuel map for pressure sensor v, throttle position etc!

Yeah, your scale is one or the other..... not both....

Dave,