924_nick

I'm installing a used Emanage blue that was formerly used on a DSM. What do I set the internal jumpers to? I'm pulling a code 13, which means #2 jumper is set incorrect.

steelrat

If you download the manual from the mohdparts, it will tell you how to set the jumpers inside for a non-vtec car.

http://mohdparts.com/emanage/index.html

Make sure the rotary dials on the front are set to 3-A-0

While you are on the mohd... you should also download the 1.20/1.40 or 1.49/1.49 firmware to make sure you have the software. I had to start with the latest full version download, then upgrade to the patches.....

Dave,

4sfed5

no ...set it to the vtec settings and then you can use the vtec out wire to switch your o2 clamp...search for my post on "NVCS"

007miata

Unfortunately since the database got deleted, that thread and most others of value are gone.

924_nick

Yeah, the dump couldn't have happened at a worse time. I just bought an EMB and now a lot of the data I was looking forward to using is to set it up just isn't here anymore. I did solve the jumper switch situation, though. Now I'm just trying to figure out the best tuning procedure.