okay, so I am back to this project. Got the vehicle speed sensor going to the right spot on the EMU (thanks Joe).

Now for the rub,
When I set the start ign cut point it works just fine, but when it hits the set point it cuts, then drops rpm a lot more than I want it to. Anyone have any suggestions on how to keep the rpm in a 500 rpm window?

 

Four months, a bigger motor and bigger supercharger later, I am once again back to the launch control issue.

Does anyone have launch control working on their EMU? Or maybe I should ask does anyone still run an EMU that could see if they get the same results?

Thanks.