Question about jumpers
I'm installing a used Emanage blue that was formerly used on a DSM. What do I set the internal jumpers to? I'm pulling a code 13, which means #2 jumper is set incorrect.
|
If you download the manual from the mohdparts, it will tell you how to set the jumpers inside for a non-vtec car.
http://mohdparts.com/emanage/index.html Make sure the rotary dials on the front are set to 3-A-0 While you are on the mohd... you should also download the 1.20/1.40 or 1.49/1.49 firmware to make sure you have the software. I had to start with the latest full version download, then upgrade to the patches..... Dave, |
no ...set it to the vtec settings and then you can use the vtec out wire to switch your o2 clamp...search for my post on "NVCS"
|
Unfortunately since the database got deleted, that thread and most others of value are gone.
:sadwavey: |
Yeah, the dump couldn't have happened at a worse time. I just bought an EMB and now a lot of the data I was looking forward to using is to set it up just isn't here anymore. I did solve the jumper switch situation, though. Now I'm just trying to figure out the best tuning procedure.
|
All times are GMT -4. The time now is 10:53 PM. |
© 2024 MH Sub I, LLC dba Internet Brands