36 / 1 Trigger Wheel Setup for ITB 1.8 ** Help Needed
 

Can someone advise how to mod a stock Mk1 CAS to run alongside a Mk2 Crank sensor for a 36/1 trigger setup for a Mk1 1.8? There is very little on the net about this, so any help would be greatly appreciated!

mk1 cas is 2 sensors, one with 4 trigger pulses and other has 1 iirc:confused:

also has 4 wires;)


although I'm probably wrong:drool:

Rich.

Cheers rich, thanks for confirming. So which of the four outputs does what - so I know how to connect my CAS and crank sensor together and back into the loom.