engine swap and now nothing
#1
engine swap and now nothing
whats up guys. i recentley bought a 91 miata that was turbo'd on megasquirt. the motor had low compression in two cyl so i ended up replacing the motor and putting the stock ecu back in the car. now my question is when i turn the key i have absolutely nothing...the fuel pump turns on but i have no dash lights at all...almost like these is nothing there. no starter click etc. The ecu does look a little haggard...it was givin to me with the car. any idea what it could be? does it sound like a bad ecu?
#8
okay guys, i checked all of the fuses and everything is good to go. Im still at a loss. i checked the fuel inj fuse cause my buddy has a 91 miata and just swapped then and still nothing. when you to the key to the on position the fuel pump primes and then literally nothing after that. The relay does not kick on for the fuel injectors (only the fuel pump) but the relay is good..
#12
Boost Pope
iTrader: (8)
Join Date: Sep 2005
Location: Chicago. (The less-murder part.)
Posts: 33,023
Total Cats: 6,591
I don't know what the problem is.
But it's something really simple.
Forget about the ECU. You can unplug it, throw it on the ground and smash it with an axe, and the starter will still turn the engine. Same goes for the fusebox- only the 80A main will prevent the starter from turning, and that's not blown or your fuel pump wouldn't be running.
This is more basic than that. You're gonna need to just start tracing wires. This is where a copy of the factory wiring diagrams is helpful.
Actually, now that I think about this, you're saying that the fuel pump was running with the key in the START position even with the ST SIG fuse missing? That's imposisbru.
But it's something really simple.
Forget about the ECU. You can unplug it, throw it on the ground and smash it with an axe, and the starter will still turn the engine. Same goes for the fusebox- only the 80A main will prevent the starter from turning, and that's not blown or your fuel pump wouldn't be running.
This is more basic than that. You're gonna need to just start tracing wires. This is where a copy of the factory wiring diagrams is helpful.
Actually, now that I think about this, you're saying that the fuel pump was running with the key in the START position even with the ST SIG fuse missing? That's imposisbru.
Last edited by Joe Perez; 07-24-2013 at 09:02 PM.
#15
Alright guys, I am so lost here. I have the car running now. It will start but runs idles very rough. Almost like a misfire. Ever since I pulled the radio out of the car to fix a speaker wire when I first bought the car it ran this way from here on out. I swapped the motor cause the old one was ****. The fuel pump was constantly running before. But I found the plug and fixed that. Made sure the fuel pump was good. Changed wires, coil packs, CAS 2 times. I checked all of the fuses inside the car and in the engine bay and they are all good. I also still have no dash lights at all. This sounds stupid but would the factory radio harness being cut have ANYTHING to do with it? I have pulled the dash out and you can tell where some wires where tapped into for the MS but other then that nothing was cut ( besides factory radio harness). The main relay is good. I've tried 2 of them as we'll....I'm lost guys.
Thread
Thread Starter
Forum
Replies
Last Post