Alright so I got the majority of my DIY turbo kit installed, when started and the wideband is on the heater the car idles fine, the second the sensor warms up it reads from 9 to 10 and then all the way up to a 22.4 and the car dies. Also after the car dies the sensor jumps back down to 18. Timing is set to a static 10 just for start up purposes, I've tried switching from lc1 to mtx-l is TS and LC1 seems to give me a closer reading to what the gauge says. No error codes at all, is it the sensor that could be bad? its reading in a linear pattern so I'm confused if it is bad, wideband is less than 6 months old. No exhaust leaks that I could find pre-sensor.

 

You suck at tuning and ASE is the only thing keeping your car idling. Nothing wrong with the mtx-l.

 

Never said I was "good" at tuning, thanks for confirming nothing is wrong with the mtx-l, I need to tune wue right? I'm confuse though because before the turbo was put on the car ran good on ms

 

Did you change injectors?

You probably need to tune accel enrich too, but the VE table is the big one. AE doesn't cause a car to stall.

Of course I'm only guessing since you don't post a log.

 

Sorry forgot to post a log I'll go grab one. I guess wue could be a culprit

 

Here, thanks for helping me out, I appreciate it.