Question about Fuel Pressure
I ended up just picking up a clean set of Toyota 315CC injectors (green tops) + new seals (since my stock injectors were leaking at the o-rings anyways). I'm in the process of trying to adjust my BEGI AFPR. The first adjustment should be cake by setting it to 50psi @ zero point (aka: base). The second adjustment requires an adjustment on full boost. I've read for hours on boards and can't seem to determine the settings I should go with.
Here's my current setup: - Greddy Turbo @ 6psi - Starion FMIC - BIPES - Walbro 190 HP Fuel Pump - BEGI AFPR - K&N Filter - Clutchnet 6-puck Clutch - Stock injectors These are my current # (bought the car with these settings): 37.5psi fuel @ idle 37.5psi fuel @ 0psi (Base point) 75psi fuel @ 6psi boost Ideal settings: 43psi fuel @ idle 50psi fuel @ 0psi (Base point) 98psi fuel @ 8psi boost* *I heard that a good rule of thumb is 6psi fuel pressure per 1psi boost, so... 50psi base + (6 x 8psi) = 98psi However, the new injectors are more free flowing (roughly 37% more flow) since 230cc -> 315cc = 37% increase My calculation @ full boost (8psi) 50psi base + (6 x 8psi) = 98psi - (98psi x .37) = 61.74psi Should I go with the "6psi fuel to 1psi boost" rule or should be running lower fuel pressure due to running bigger injectors? I'd imagine that I would need less pressure with bigger injectors. Should I rely on my calculation of 61.74psi or go with the 98psi recommendation? Any thoughts? Unfortunately I don't have a wide-band A/F gauge or EMS (maybe down the line). |
Wide band. Then experiment. Not down the line, now.
|
Definitely going wide band soon, but I have an AutoX event this weekend and I'm not sure running leaky injectors is a good idea ;P Any suggestions on fuel pressure in the meantime?
|
Since you are running 315's, I would leave the settings where they are for the autocross.
This is based on a very old set up that I ran with 1.8 injectors at 80psi which was slightly on the rich side at 8psi. Definitely get yourself a wideband. There are too many variables in your system to be shooting in the dark. |
if you see 38psi at 0psi, your oem FPR is broke.
|
All times are GMT -4. The time now is 06:27 AM. |
© 2024 MH Sub I, LLC dba Internet Brands