Tacho connection on NA with NB engine
Hey everybody,
I just installed new engine to my NA from NB 1.8 103kw. Everything now runs fine, just don't know where i can get tacho signal to my old speedometer console. Maybe somebody can suggest what to do? |
are you still using the stock coils?
|
no, everything on engine are new from NB.
|
the NB coils don't have the ability to send out a tach singal like the early NA coils. I'm assuming you hacked into the wiring to run them? otherwise I would have just used my NA coils and there wouldn't have been a problem.
|
I would like to leave coils from 1,8. Because now when everything runs fine, just don't want to change something until i will get MS. But where was signal on NB? It was from ECU? I know that NB console has microcompuer wich is making signals to right. But some signals must go in from ecu or somewhere whiches controls tacho.
|
yeah the NB ECU outputs the signal, are you using the NB ECU?
If so, what model year and I can tell you which pin to use and where to route it to. |
All swap was taken from 1999year. 1,8 103kw .
|
So pin 2K grn/org is the tachout from the ECU. You'll have to wire it to yellow/blue wire coming into your instrument cluster.
or back to the yellow/blue wire on the ignitor wiring or the yellow/blue wire coming off IG- on the diagnostic connector. |
Thanks, i will try it and respond you :)
|
Undoing the cam sensor on an NB will disable the tacho as well.
|
Everything works fine, thanks for information :)
|
All times are GMT -4. The time now is 08:57 AM. |
© 2024 MH Sub I, LLC dba Internet Brands