gobs331 |
11-15-2014 01:04 PM |
tunerstudio afr gauge stays at 7.4??
I installed my lc1 wideband and diypnp ms. My db gauge for my wideband will work but my tuner studio gauge stays at 7.4 no matter what, I have be trying to get tuner studio to run an autotune on my 93 miata but autotune will not respond. Im assuming its because it will not get a reading from my lc1 controller. I contacted diyautotune with questions they pointed out i missed a step and need to connect my yellow lc1 wire to my ecu. I then did so and my gauge then read 10-10.3 and would stay there which wasn't matching to what my db gauge was reading and it made no adjustments when throttle was applied or anything.
When i connect the yellow wire to the ecu the car runs really rough, db gauge fluctuates a lot blinks 7.4 every few moments, compared to when its not connected car runs decently well db gauge works smoothly.
Diyautotune also said i need to connect my lc1 to lm programmer to set up the yellow wire to match the output currently on the brown wire. I can not get lm programmer to recognize my "device"
|