Link ECU Hybrid Mess
#1
Newb
Thread Starter
iTrader: (1)
Join Date: Nov 2008
Location: San Antonio TX
Posts: 25
Total Cats: 0
Link ECU Hybrid Mess
Sorry if this seems like a noob post but I really have no idea where to go from here.
Perhaps I've jumped the gun on this little purchase, but I bought a Link ECU to install in my 1.6. I was told by the seller that it was used in a 1.6 car but upon receiving the computer, it appears to be the Obiwan board. It is in a BP ecu case and has the 4 pin connectors. Obviously, the 1.6 harness only has 2 connectors for the ECU (which do plug into 2 of the slots on the board); so my question is, can I make this work, or would I be better off just selling it and getting a 1.6 board?
I found this: http://www.flyinmiata.com/support/in...BD2_rewire.pdf but it's for OBD1 1.8 to OBD2 1.8. Sorry if this seems a bit "noobish" but i'm just really at a loss with this thing and just want to be able to tune the car and go faster!
Perhaps I've jumped the gun on this little purchase, but I bought a Link ECU to install in my 1.6. I was told by the seller that it was used in a 1.6 car but upon receiving the computer, it appears to be the Obiwan board. It is in a BP ecu case and has the 4 pin connectors. Obviously, the 1.6 harness only has 2 connectors for the ECU (which do plug into 2 of the slots on the board); so my question is, can I make this work, or would I be better off just selling it and getting a 1.6 board?
I found this: http://www.flyinmiata.com/support/in...BD2_rewire.pdf but it's for OBD1 1.8 to OBD2 1.8. Sorry if this seems a bit "noobish" but i'm just really at a loss with this thing and just want to be able to tune the car and go faster!
Thread
Thread Starter
Forum
Replies
Last Post
bigmackloud
Miata parts for sale/trade
19
01-08-2021 11:24 AM