Originally Posted by Mr.E.G.
(Post 1042741)
One day I will face this same dilemma when I inevitably blow up my 1.6 but I can't fathom switching to a 1.8. Don't get me wrong, I'm sure it's better but I can't imagine having to ditch my turbo setup. I'll just go with a built 1.6.
|
Originally Posted by Mr.E.G.
(Post 1042741)
One day I will face this same dilemma when I inevitably blow up my 1.6 but I can't fathom switching to a 1.8. Don't get me wrong, I'm sure it's better but I can't imagine having to ditch my turbo setup. I'll just go with a built 1.6.
|
Originally Posted by Fireindc
(Post 1042748)
Ignoble peasant.
|
1.6 can't even boost.
|
4 Attachment(s)
So I got under the car yesterday and found oil all over the place, but only on the bottom side of the turbo and the parts underneath and around that area. It was pretty clean for at least a couple weeks before this happened.
See attached pictures. With that in mind, and the sound from the video below, does that help anyone have a better idea of what actually broke inside the engine? I thought it might be a spun bearing at first, but I have zero real experience with the insides of an engine. I'm still not sure what route I'm going to go: fix this engine, used 1.6, used 1.8 and then exhaust manifold and everything else that goes along with it. |
without reading the thread or knowing any backstory, that sounds (and LOOKS) like an exhaust leak to me.
and I HATE your drain. |
Originally Posted by Braineack
(Post 1047324)
that sounds (and LOOKS) like an exhaust leak to me.
|
it wouldn't.
|
ok, then what in the pictures indicates an exhaust leak?
|
the video. something is flapping in wind between #2 and #3 at 0:11. and the sound is more promenent on the driver side.
|
ah, ok, I can check that.
And the oil spray?? |
i hate that 90° right off the turbo, probably has a lot to do with it.
|
i hate it too. The PO installed it and I did not change it.
|
Brain,
I found adapters on BEGi, which is where I am assuming it came from. AN Adapters / Fittings - BEGi I'm guessing I have the "1/8 NPT to -4 Adapter, 90*". Could I just change it to a "1/8 NPT to -4 Adapter "? EDIT: Or maybe it is the "Oil Drain Fitting -8" That may make more sense than the -4. http://www.bellengineering.net/produ...products_id=91 |
4 Attachment(s)
I have a new video and data log.
I did find an exhaust leak. The rear studs on the manifold/turbo were loose. Also, there is some oil leaking from the oil drain fitting. I took this video after fixing the exhaust leak. The car nearly stalled a couple times and sounds pretty rough. The data log was recorded at the same time as the video. |
it sounds "better" but i dunno bro.
|
Thanks, Brain. Anyone else have any ideas about the engine noise/stalling?
|
Compression/leakdown?
|
It sounds valvetrainish.
Can you localize the sound? Louder from above or below? With the oil leak, how low did it get? If and when you pull the engine, make sure you get a coolant reroute in there. |
The oil is still about full. I have a stethoscope and I can't pinpoint it from the top or sides. I have not tried the bottom.
|
All times are GMT -4. The time now is 06:55 PM. |
© 2024 MH Sub I, LLC dba Internet Brands