Custom ignition wires.
#5
Senior Member
Thread Starter
iTrader: (20)
Join Date: Dec 2008
Location: Austin, TX
Posts: 736
Total Cats: 8
They are identical.
$72 from Renown
DIY wants 67, and I don't think they come with the connector to wire them($5 from DIY) Which surprisingly adds up to the cost of the AEM, so i'm going with the AEM.
Since we are on the subject of Magnecor.
Should I get the 8.5mm or the race 10mm.
anybody have any experience.
$72 from Renown
DIY wants 67, and I don't think they come with the connector to wire them($5 from DIY) Which surprisingly adds up to the cost of the AEM, so i'm going with the AEM.
Since we are on the subject of Magnecor.
Should I get the 8.5mm or the race 10mm.
anybody have any experience.
#8
https://www.miataturbo.net/attachmen...0&d=1327453916
the classic broken oil dip stick, lol
very neat setup
the classic broken oil dip stick, lol
very neat setup
#13
mkturbo.com
iTrader: (24)
Join Date: May 2006
Location: Charleston SC
Posts: 15,176
Total Cats: 1,680
I rather not have my coils on the hot side. I am afraid of the heat there from my turbo. Also the LS2 coils I have are around shape so you cannot easily mount them flat. I have mine up on brackets above my IM, it is not at pretty as I would like, but it is functional.
#16
VVt coil mount bracket
I was worried about the mounting them on the hot side too . I built the bracket with that wing/heat shield to give them some protection. My turbo and manifold are both ceramic coated so that should help some as well. Once the snow melts here , I guess I'll find out if the heat is going to be a problem or not .
Thread
Thread Starter
Forum
Replies
Last Post
SuperSneakySecretSquirrel
Meet and Greet
5
09-06-2015 08:30 PM