1.8 swap: noob question
if i'm MS, and planning on using the TB that came attached to my 2002 motor, all i should need as far as parts to do the swap into my 1993 chasis are the two motor mount brackets, and an EGR blockoff, correct?
Secondly, those brackets could just come from any 94-97 car. also correct? |
I'll do this in list form
|
I am doing the samething soon. I was told the cas from our 1.6 will plop right in on the back of the exhaust cam. If you look back there it is just like the back of the intake cam on the 1.6 and u just remove the bar they have blocking it off and install our cas. (i have not done this yet so if i am wrong please say so).
VVT is controled by the 200 dollar box diy sells http://www.diyautotune.com/catalog/v...7e836194ff7e69 I am very interested in if I need the egr block off plate and if I can use my existing mounts from my 1.6 so please report back if you try. The flyn miata kit also notes some wire to extrend the cas. I am un sure if you could just use any wire and soldier it to extend but I figure you could. I have a bmw vtps and am hoping it will plug in to the nb TB like it did the 1.6 but I dont know for sure. |
One of my concern is the idle control. THe 1.6 is a one wire valve and the 01-05 1.8 is two wire so i am not sure how to conect it?
|
actually I was reading more one the diyautotune vvt controler and it says it
"This one also translates the NB crank and cam sensor signals into NA style signals, making it perfect for swapping the VVT head into earlier Miatas" |
Savington posted in a thread over on Miata.net several months ago detailing this exact swap.
|
link please, dan? i am full retard when it comes ot search and didn't find it over there in my first four point two minutes.
feed me, seymour, feed me. |
I'm on vacation and using my phone, so no can do.
Advanced search Post by...Savington Section... Engine swap or power mods can't remember for certain. |
ok, no prob. i'll find it when i have more time. thanks for the heads up.
|
Nevermind... I cannot say for certain so feel free to delete this reply.
|
What about the idle valve the 90 is 1 wire the 01-05 is 2 wire?
|
All times are GMT -4. The time now is 09:17 PM. |
© 2024 MH Sub I, LLC dba Internet Brands