2.5 DP -> 2.75 cat -> 3 inch out
Anyone done this without welding. I am wanting to run my 2.5 fm downpipe and bolt it up to a 2.75 cat to a 3 inch catback. I figure since its only going up .25 each connection it may be alright? :confused: I see guys running 2.5 downpipes to stock exhaust so I figure I am in the clear.
|
if your question is "is it possible" then the answer is yes.
been there done that *edit: actually it depends on your flanges, but most of them should let you get away with it. |
Thanks 18psi for the quick reply. I hope I wont be battling potential exhaust leaks. Part of me is very nervous as I hate jerryrigged things. Hmm maybe Ill get a 2.5 to suffice until I can go full 3 inch all the way.
|
that's a terrible idea.
if you're starting from scratch right now, there's no reason not to go 3 |
Well I already have a 2.5 downpipe. Wife would kill me if I bought a full 3 inch exhaust right now. I have my eye on cheap 2.5 straight exhaust on the classifieds and I have 2.5 inch magnaflow sitting in my garage from another project I had. So I could just get it welded up. idk.
|
You want a nice 3" midpipe? Mine's off an NB though not sure if it would fit (though I don't see why not). It tapers to 2.5" at the very back, so you could bolt it to your maggie
|
I been reading around and people are saying the hangers are in different spots
|
I ran something like that and it made good power. Now, my AbsurdFlow with larger turbo and full 3" spools better, but it's from another universe.
|
I bet haha.
|
All times are GMT -4. The time now is 01:43 AM. |
© 2024 MH Sub I, LLC dba Internet Brands