Engine Performance This section is for discussion on all engine building related questions.
Sponsored by:
Sponsored by: KPower

Car trys to start then dies. ran at first but now will not

Old 09-15-2012, 01:48 PM
  #1  
Senior Member
Thread Starter
iTrader: (3)
 
90 Turbo's Avatar
 
Join Date: Sep 2011
Location: Plano TX
Posts: 595
Total Cats: -1
Default Car trys to start then dies. ran at first but now will not

Ok i changed the radiator and found a spot for my temp sensor. I did not think i messed with anything else. I messed around back by the cas to hook up the dash temp sensor.
its DIYPNP so i reloaded firmware and base map.

after radiator and down pipe removal and new rad installed and downpipe reattached. started the car no problem ran for about 30sec-90sec then died. just all of a sudden died would try and start back run for a second after the key was released even build rpm to 2k or so but not start really.
Came back 10min later started for 30-45 sec then died again.

I changed Cas
coil
battery
afr look fine.
reflashed firmware and reset everything

I am so frustrated.
90 Turbo is offline  
Related Topics
Thread
Thread Starter
Forum
Replies
Last Post
ReallyRottenTurbo
MEGAsquirt
4
09-22-2015 12:49 PM
huesmann
MEGAsquirt
19
09-16-2015 07:11 PM
bigben
Race Prep
16
09-11-2015 03:41 PM
shanesauce
General Miata Chat
1
09-06-2015 08:47 PM
Motorsport-Electronics
ECUs and Tuning
0
09-05-2015 08:02 AM


Thread Tools
Search this Thread
Quick Reply: Car trys to start then dies. ran at first but now will not



All times are GMT -4. The time now is 06:43 PM.