CAS Male Connector to not cut harness
I have searched and searched but I think my key words are off. I have a 94 NA I am swapping a MSM engine into. Currently rewiring the CAS wires to handle a cam and crank sensors. I am trying to avoid cutting the harness. What I am looking for is a male connector I can plug into the stock CAS 4 prong harness and wire into the sensors. Does it exist?
|
I do not believe the connector you want exists. I have cut them out of old coil packs before.
|
1 Attachment(s)
If the male connector is not available you can depin the female and use a 4 way that uses the same terminals and male/female are both available , like below. I believe the bottom 4 connector is the one you currently have?
Attachment 227559 |
Yes the harness you want does exist. I bought one from ballenger and posted about it in my build thread and in the na to vvt swap thread.
|
|
|
https://speedyefi.com/product/94-miata-maf-delete-plug/ or pay the guys at speedyefi 25 bucks for the same pigtail.
|
Originally Posted by msmola2002
(Post 1582994)
https://speedyefi.com/product/94-miata-maf-delete-plug/ or pay the guys at speedyefi 25 bucks for the same pigtail.
|
OP is asking about the CAS to cam and crank trigger sensors. Not maf.
|
Ah shitballs
that one does exist at ballenger too. Which andy found. I'll see myself out. I used one of those sold as a 12" extension, to troubleshoot that my wiring harness was bad, https://www.bmotorsports.com/shop/pr...oducts_id/4162 I was planning to do the same as OP, but since I had broken wires in my harness, I cut the harness and used deutsch connectors to make a harness to the CAS, and am about to make one to to go from DT4 connector to crank and cam sensors. |
Originally Posted by msmola2002
(Post 1582992)
Sweet. i will give this a look. |
Looking at this example I assuming it is from the CAS point of view and not the plug? I mention not because unfortunately the generic plugs I bought are not color coded or marked. Anyone know a way to tell which wire is which on these plugs?
https://cimg4.ibsrv.net/gimg/www.mia...ec8f608b53.png https://cimg2.ibsrv.net/gimg/www.mia...5c1cecc24.jpeg https://cimg3.ibsrv.net/gimg/www.mia...6a47f0452.jpeg https://cimg4.ibsrv.net/gimg/www.mia...b835ae9c4.jpeg |
Originally Posted by farpolemiddle
(Post 1582961)
I have searched and searched but I think my key words are off. I have a 94 NA I am swapping a MSM engine into. Currently rewiring the CAS wires to handle a cam and crank sensors. I am trying to avoid cutting the harness. What I am looking for is a male connector I can plug into the stock CAS 4 prong harness and wire into the sensors. Does it exist?
I highly recommend new female plugs with this connector. Currently using this to connect LS coils on my 94. |
All times are GMT -4. The time now is 10:55 PM. |
© 2024 MH Sub I, LLC dba Internet Brands