Drawing needed for torque plate
Machine shop is making me a torque plate. As I'm too lazy to measure it myself, does someone have a drawing showing the head stud, and cylinder bore locations?
BP engine |
Rent the one from FM?
|
I'm in Canada, so shipping is $$. This machine shop does a lot of work for me, so they're making it for me basically free.
|
Can someone confirm the head studs are all an equal 91mm apart?
|
Originally Posted by DirtSquirrel
(Post 1354396)
Machine shop is making me a torque plate. As I'm too lazy to measure it myself, does someone have a drawing showing the head stud, and cylinder bore locations?
BP engine
Originally Posted by DirtSquirrel
(Post 1354430)
Can someone confirm the head studs are all an equal 91mm apart?
|
Haha. Well, the reality is the machine shop said they could start it today if I give them the measurements, and I don't have an engine here at work to measure.
|
Originally Posted by 18psi
(Post 1354432)
Hold on let me do it. Wait, I'm too lazy. Nvm
|
Here's what I measured if anyone is interested.
https://cimg2.ibsrv.net/gimg/www.mia...90b3fc062a.png |
Finally got it test fit today.
https://cimg9.ibsrv.net/gimg/www.mia...3581db7577.jpg |
That is gonna give you such a low compression you can run infinite amount of boost
|
Yeah, these new head-gasket spacers are getting silly...
:rofl: |
I may sound stupid, but what's that used for?
I gave you poscats for sharing the info though even if you had to get it yourself. good sport |
Originally Posted by G3ML1NGZ
(Post 1367984)
I may sound stupid, but what's that used for?
I gave you poscats for sharing the info though even if you had to get it yourself. good sport --Ferdi |
All times are GMT -4. The time now is 05:02 AM. |
© 2024 MH Sub I, LLC dba Internet Brands