Head Bolt/Stud Length and Thread
Hey guys, kind of an oddball question from mazdatruckin.com we are trying to find a cheap alternative to spending $300 for a custom set of head / main studs, closest thing we can think of which might work is for the Miatas. If anyone can post specs on the bolts or ARP studs for either the cylinder head or main caps we would be grateful. Important dimensions are thread size, pitch, and length going into the block and overall length, for bolts this needs to be without the head thickness of coarse.
I did some searching and found a few minor specs but nothing that ruled out their use in the F2 engine. Thanks, K6 |
Man, I wish I were at home right now. I've got two full sets of both stock and ARP head & mains sitting there...
The only thing I can say off-hand is that the head bolts are a rather unusual thread; M11 x 1.5, if I recall correctly. Can't answer for length on them. I tried fitting a 7/16" nut onto one of 'em while building up a leakdown-test plate, and it almost fit, but not quite. |
Originally Posted by Kyrasis6
(Post 462085)
Hey guys, kind of an oddball question from mazdatruckin.com we are trying to find a cheap alternative to spending $300 for a custom set of head / main studs, closest thing we can think of which might work is for the Miatas. If anyone can post specs on the bolts or ARP studs for either the cylinder head or main caps we would be grateful. Important dimensions are thread size, pitch, and length going into the block and overall length, for bolts this needs to be without the head thickness of coarse.
I did some searching and found a few minor specs but nothing that ruled out their use in the F2 engine. Thanks, K6 arent there motors in the ford line that might be similar? |
Hello
i'm upping this post to know if some one could notice the studs dimensions ? For head and engineThx |
All times are GMT -4. The time now is 08:45 PM. |
© 2024 MH Sub I, LLC dba Internet Brands