boileralum |
05-17-2009 07:42 PM |
Help - car won't start after turbo/ megasquirt install
Not sure where to post this, since I'm not sure where my problem lies.
I just finished bolting everything together on my DIY turbo kit. In the process I pulled the motor to drill and re-seal the oil pan, install clutch & flywheel, etc. I even had the diff out to replace the axle seals. So, I had the car torn apart. I also installed freshly serviced 550cc RX-7 injectors and a MegaSquirt standalone that Braineack built for me over the winter.
I was finally to the point of starting the car today, and when I tried, the starter was turning slow and sounded like it might have been grinding a little. After the first attempt to start though, the car was not turning over. I thought that it was the battery (car has been sitting on jackstands since the end of March), so I tried jumping it (which involved 2 sets of jumper cables due to how I have the car parked), and still couldn't get it to turn over. I then bought a new battery, and it still will not turn over when I turn the key. I tried putting the stock ECU back in, and still nada. I hear the fuel pump behind me, but can't hear if the solenoid is clicking on the starter or not. I put a socket and wrench on the crank pulley and the motor turned over freely by hand, so I don't think the starter is jammed. I checked all the grounds I could find (under brake master cylinder, under throttle body, on PPF by the diff, and right above the battery) and all seemed well. I am leaning towards an issue with the starter. I do remember dropping it about 6-12" when I was removing it from the pulled engine, which I suppose could have killed it, but the fact that it was trying to turn the car over earlier makes me think it might be something else. Does anyone have any other ideas?
|