I've reviewed a few threads on switching to LS coils, but I'm still a bit confused as to how the wiring is setup. The wiring setups I've seen have mostly been for NAs. I have an NB1.

Could anyone point me in the right direction? I'm thinking I could probably figure it out if given a pinout on the coil connectors (harness side).

I'll make an expert MS paint diagram when finished.

 

https://www.miataturbo.net/diy-turbo...-thread-82744/

http://www.yorbalindamiata.com/image...g/2000wire.pdf

Wiring shouldn't be any different than the diagrams you found, other than wire colors. Black is ground, black/white is power from main relay, brown/yellow is signal from coil 1, brown is signal from coil 2.

 

Totally missed that thread! I should've searched for "lsx coil" instead of "ls coil" haha. Thank you!