Main bearing clearance opinons
Alright, so I'm in the middle of a rebuild on my 96. Regular old 1.8... Anyways I was plastigauging my oil clearances on the main bearings and this is what I got
main1 main2 main3 main4 main5 0.0014" 0.002" 0.0015" 0.002" 0.0014" 0.002"=0.051mm 0.0015"=0.038mm now I know that plastigauge is not 100% accurate but it should be pretty close. And as per instrustions I measured at the widest point although the smashed plastic was pretty uniform. (I measured once then again cleaning main bearing seats/threads both times and torqued to 42 ft.lbs as per haynes) My question is, in my haynes manual and everywhere else I have seen, it quotes "Standard-- .0007"-.0014" Service limit-.004" I'm definitely under the service limit but why is the service limit so far from the "standard"? This is with new clevite 77 standard size bearings. Will I be okay running this?(mostly worried about oil pressure) and is this out of the ordinary? What clearance is everyone else seeing? Thanks anyone who helps! --Joe |
Comon brothers I see you viewin my post unless those were my 40 views checking back to see if anyone said anything lol which they werent.
I'll probably just run it anyways but I wanna hear your opinions! maybe this will attract you :yippee: |
Your clearances are fine. I'm at .0025-.0032" and I have marginally low oil pressure. You 1.4 to 2 thou is fine.
|
Alright sweet that's exactly what I was looking for, Thanks!
|
All times are GMT -4. The time now is 01:31 PM. |
© 2024 MH Sub I, LLC dba Internet Brands