Mistake with oil ring expander
Hello!
I have a doubt that has me worried. I have installed the 83.50 Supertech pistons rings in my engine as indicated in the picture of the guide. But I have made a mistake and I do not know if it is very serious. I Placed the oil ring expander into the oil groove with the butted tips of the expander 45 degrees from either end of the wrist pin as the following picture shows: https://cimg2.ibsrv.net/gimg/www.mia...d309588d84.jpg The image has confused me I believed that all oil rings had to place to 45 degrees from the wrist pin. I have already assembled the entire engine. After this I have read the installation guide again and I have read that the expander has to be at 90 degrees!! The expander are correctly butted… Is it a very serious mistake? Or can I continue as is? I do not want to disassemble the engine again for not breaking the cylinder head gasket and other gaskets ... https://cimg2.ibsrv.net/gimg/www.mia...9c3dd8e284.png I appreciate your help. Thanks! |
So your oil expander is off by only 45 degrees? I would not worry about that, there is plenty of margin. I think I would only worry if it was off by more than 90 degrees.
|
thanks for the answer, this is how I placed the oil ring expander:
https://cimg1.ibsrv.net/gimg/www.mia...9fe003c10.jpeg |
I sent the question to supertech and this is the answer:
This is no big deal. You are fine. Already solved! |
You are fine just send it.
|
All times are GMT -4. The time now is 03:43 AM. |
© 2024 MH Sub I, LLC dba Internet Brands