No power to coilpack
 

Been trying to figure out why Im not getting any spark after I had 30 volts go thru my system. Ive replaced the coilpack, plugs, and plug wires. I've double checked that Im getting power to my CAS, but haven't check the CAS itself, although its fairly new. I've also checked and replaced all the main fuses.

I checked to see if theres any voltage coming out of the wires that go to the coilpack.... nothing, not even when I crank it over. What all could stop the current from flowing thru those wires, a short?

Engine turns over fine and it ran fine before the 30 volt overcharge. Mind you I had it running on a MSPnP, but it was fired and now Im using my stock 97 ECU.


Im slowly tracking this down, I'd just like some help :)

No ideas from anyone?

Hate to throw out the obvious, but have you checked all the main fuses and such already?

Yes, but thank you for the feedback!

did you find out what it was?

Haven't touched the car since this thread was made lol.

Getting ready to try to fix it next month with a new MS.

hmm i am having some problems too. i just need some time off work to mess with it

Primary power to the coilpack comes in on the blue wire. It does not pass through the main relay, it comes through the 80A Main fuse, then the key switch (IG1 position) and that's it.

If you're getting power on that line, but not getting signal coming in on the brown and brown/yellow wires, that's a whole different ballgame.

this is my problem!! i dont have signal