Recommended machine shops in CA
 

In a few months I will finally be ready to have my stock VVT engine built. I will be using manley h beam rods, 8.6CR 84mm supertech pistons w/ wiseco rings, ACL Main/Rod Race bearings (I bought STD size bearings, hopefully my crank will work with these), ARP head stud and main stud hardware, BE oil pump, supertech +1mm oversize intake and exhaust valves, supertech double springs, Mazda SUB lifters, super miata harmonic damper, and squaretop intake manifold. I am going to be replacing every seal/gasket as well. I was wondering if anyone has experience or knows of any good machine shops in California that are familiar with building a performance mazda BP motor. I am located near Monterey,CA so somewhere not too far from here would be better. Thanks in advance!

-David

I'd reach out to Twibs415 here on MT... he's up in San Francisco and may be able to help you out.

This is who I used for my recommended to me by a spec miata engine builder. They can do a 4 and 5 angle performance valve job.

BPE Racing Heads: labor prices

I disassembled and cleaned the head first and dropped it off with a +1mm intake and +1mm exhaust valve.
They cut the valves seats for me and blended the throat some.
I reassembled and did the valve lash adjustments myself.

They can also do the whole head from start to finish as well

I used catsillo's crankshaft to regrind my crank.
https://www.yelp.com/biz/castillos-c...list-la-mirada

The rest of the work I did myself.