Samakhans K swap Miata build
 

For anyone that is interested in following my K20 Miata swap, I've created a facebook page simply to make it easier for myself to post updates and progress in one spot rather than 5+ Mazda/Honda forums I am a member of.

https://www.facebook.com/samakhanskswapmiata

Like the page if you wish. For those that don't have Facebook, I'll try my best to post updates in here any chance I get.


I purchased the Kmiata kit and am using a k20a2 from a 2003 Acura RSX Type-S.

Ultimately, I am planning to do a mild engine build and bolt on a C38-91 Rotrex Supercharger in hopes to make ~400whp/300ft/lbs torque

The car will be my summer cruiser/track toy.

https://fbcdn-sphotos-h-a.akamaihd.n...25581970_o.jpg
https://fbcdn-sphotos-c-a.akamaihd.n...08284115_o.jpg
https://scontent-atl.xx.fbcdn.net/hp...8e&oe=557C32C8
https://scontent-atl.xx.fbcdn.net/hp...10&oe=554C388A
https://scontent-atl.xx.fbcdn.net/hp...bb&oe=557F8B3E
https://scontent-atl.xx.fbcdn.net/hp...35&oe=559326C6
https://scontent-atl.xx.fbcdn.net/hp...d2&oe=55758247
https://fbcdn-sphotos-h-a.akamaihd.n...1bf347009b1e80

Potential for much fabulous!

That car is beautiful.

Enjoy your snow! I have a lot of family up in Mequon.

so youre the first one to do this to an na?

You people and your k swaps.... My v8 leanings are going to end up being swayed

Thats a hell of a lot of power for a miata. Sounds fun

K MIATAS EVERYWHERE

Looks great Sam. This is going to be a great build.

Cant wait to see how this thing comes out man goodluck on your build

My brother, njn63 is doing a k24a2 into a na (93). He's on here his is pretty close to being done.

Saturday's project involved de-powering the NB Miata power steering rack. Getting rid of power steering is a little more complicated than removing just the pump and looping the lines together. To clear the Kmiata pan, the fluid inlets on the rack body itself needed to be ground off and welded shut. The rack was completely taken apart to remove all seals to reduce friction and the shaft was turned on the lathe to remove a few millimeters of material off the piston seal to reduce friction as well. Also slop in the steering is caused by space between the splines on the 2 piece pinion shaft which I had my good friend Chubz weld together. All said and done, the steering should be tight and responsive.

https://www.miataturbo.net/attachmen...ine=1425916350

I am excite!