Engine Performance This section is for discussion on all engine building related questions.
Sponsored by:
Sponsored by: KPower

engine vibration at 3.5k rpms

Thread Tools
 
Search this Thread
 
Old 03-25-2013, 11:51 AM
  #1  
Newb
Thread Starter
 
LeroyTurbo's Avatar
 
Join Date: Mar 2013
Location: Chardon Ohio
Posts: 33
Total Cats: 0
Default engine vibration at 3.5k rpms

ok, so I'm getting a low vibration (I mainly feel it through the gas pedal and floor) when the car runs steadily at 3.5k rpms or higher. (so basically freeway driving) it happesn in any gear, when I'm NOT in boost, just cruising along. and it never happens when I'm below 3k rpms.

I did replace the flywheel with a lightweight one, did I mess up the engine balancing? what else could this be?
LeroyTurbo is offline  
Old 03-25-2013, 07:58 PM
  #2  
Newb
Thread Starter
 
LeroyTurbo's Avatar
 
Join Date: Mar 2013
Location: Chardon Ohio
Posts: 33
Total Cats: 0
Default

it also happens when the car is sitting still. any ideas?
LeroyTurbo is offline  
Old 03-25-2013, 08:06 PM
  #3  
Senior Member
 
Miater's Avatar
 
Join Date: Aug 2010
Location: Arl. Texas
Posts: 936
Total Cats: 27
Default

We know nothing about your car, what year, engine,trans....


Light weight flywheels can and will cause more than normal drive line vibration. Removing the trans and not getting everything you put in balanced, together, can cause this. Clutch, pressure plate, flywheel can and should be balanced before installing. This is not overly necessary and was mentioned because it could be an issue.

What fly wheel do you have? Clutch? PP?

Sometimes the drive shaft needs to be put back in the order you found it, Diff flange bolts...

I read that it does it while sitting still. That tells you it's most likely in the clutch, fly, PP.

You could be the owner of an unbalanced flywheel.
Miater is offline  
Old 03-27-2013, 01:11 PM
  #4  
Senior Member
iTrader: (9)
 
Rallas's Avatar
 
Join Date: Oct 2006
Location: Lexington SC
Posts: 1,176
Total Cats: 35
Default

I have a similar mistery vibration at 3600rpm. Not as severe, just enough that I hear what sounds like a heatshield vibration. Mine does it in all gears and when stopped too. This is on a 96 engine with nothing special, resurfaced flywheel and new clutch ~15k miles ago, but only recently developed the vibrating sound. Something is resonating at that speed. It will go away +/-50 rpm from 3600.

OP did you experience the vibration immediately after you made the last changes? Does the vibration go away above a certain RPM?
Rallas is offline  
Old 03-30-2013, 07:51 AM
  #5  
Newb
Thread Starter
 
LeroyTurbo's Avatar
 
Join Date: Mar 2013
Location: Chardon Ohio
Posts: 33
Total Cats: 0
Default

i also have a 96. and it isn't the tranny, because it does it even when sitting still.
no the vibration does not go away above any rpm. however, i replaced the spark plugs yesterday and set them to .03", and it got substantially better.

the last change i made was to put a turbo, lightweight flywheel, and new computers on it- and yep, it happened right after that change.
LeroyTurbo is offline  
Old 03-30-2013, 11:10 AM
  #6  
Senior Member
iTrader: (3)
 
Clos561's Avatar
 
Join Date: Nov 2009
Location: Royal Palm Beach, FL
Posts: 725
Total Cats: 5
Default

1 million dollars says your downpipe is hitting the transmission tunnel near the gas pedal. ask me how i know......
Clos561 is offline  
Old 03-30-2013, 08:30 PM
  #7  
Newb
Thread Starter
 
LeroyTurbo's Avatar
 
Join Date: Mar 2013
Location: Chardon Ohio
Posts: 33
Total Cats: 0
Default

I don't believe that it is... But it's worth checking. Thanks for the suggestion.
LeroyTurbo is offline  
Old 04-14-2013, 07:59 AM
  #8  
Newb
Thread Starter
 
LeroyTurbo's Avatar
 
Join Date: Mar 2013
Location: Chardon Ohio
Posts: 33
Total Cats: 0
Default

any more ideas be chance? the down pipe was not hitting anything.
LeroyTurbo is offline  
Related Topics
Thread
Thread Starter
Forum
Replies
Last Post
Full_Tilt_Boogie
Build Threads
84
04-12-2021 04:21 PM
90 Turbo
MEGAsquirt
19
10-19-2015 03:23 PM
tazswing
Race Prep
20
10-03-2015 11:04 AM
JesseTheNoob
DIY Turbo Discussion
15
09-30-2015 02:44 PM
viriiguy
General Miata Chat
5
09-28-2015 07:39 PM



Quick Reply: engine vibration at 3.5k rpms



All times are GMT -4. The time now is 11:03 AM.