Wiring Pinout for A/T TPS
 

Alright, before any of you say "Just research it", I've looked all over the internet trying to find the right pin out for this damn connector.
When I ask this question, IGNORE COLORS. I do not have the exact pigtail that came with the VTPS, I have one that fits, but has different colored wires.
The pin out for the non-variable TPS is as follows:
https://cimg5.ibsrv.net/gimg/www.mia...bf05b1f788.png
Now, can anyone show the corresponding information but on the A/T VTPS?
https://cimg2.ibsrv.net/gimg/www.mia...00b6f0ea71.jpg


The model number is JE50 18 911

what year miata? I'm assuming 1.6L here?

Yep its going on a 1.6L

sorry its a 1990, if that makes a difference

Does this help? From top to bottom should be 5V ref, TPS Signal, open pin, Signal ground.

Wiring Up An Auto Vtps - Forced Induction & N/A Power Mods - MX5Nutz Forum

https://cimg4.ibsrv.net/gimg/www.mia...6a113f4e0e.jpg


This picture would help a lot if I knew which wire doesn't get used and if i could see the colors more clearly. (Middle two both look the same)

The wire labeled idle switch in that picture is unused.

What do colors matter, didn't you say so yourself? There's plenty in that picture to get you going.

I used to have the perfect image, but its no longer online.

just look at the 92 service manual:

http://www.miataforumz.com/1990-200-...Manual1992.pdf

the wiring diagram section shows the pinout and wire colors.


https://cimg9.ibsrv.net/gimg/www.mia...cf499ff095.png


1N (R) is on/off idle switch
B/LG is Ground
LG/R is 5V
2M (R/B) is vTPS signal

This is perfect, thanks guys. I had a schematics from the haynes manual but it was wrong when it came to the wire colors on the TPS for the 1.6, so I couldnt trust it.

And yes the colors didnt matter if someone was just telling me the pin out, but with the picture I could do some simple translating and understand which colors they were talking about. Anyway, Thanks again.