ACL Race Bearing Inventory - BACK IN STOCK!
Alright guys - we've recently been contacted by a number of engine manufacturers looking for ACL bearings. There seems to be a shortage (with quite a long ETA) and we have a few sets left (8 complete sets total)!
We also stock the Mazda larger thrust washers for those building 01-05 blocks. Link: ACL Race Bearing Set - Miata https://farm8.staticflickr.com/7295/...f1cf0a56_z.jpg |
We now have them back in stock! This morning we opened up a stocking order from them with 25 sets of main bearings. They are now enabled on the site and shipping same day.
Link: ACL Race Bearing Set - Miata https://www.miataturbo.net/attachmen...ine=1450300645 |
Do you expect the shortage to happen again at some point?
|
Originally Posted by aidandj
(Post 1292665)
Do you expect the shortage to happen again at some point?
|
Literally days after I ordered the Kings. Either way I'm sure they work great.
|
The plant in Australia shutting down was the cause of the inventory issues.
When I spoke with the ACL USA folks at PRI I was told there is no reason to believe there will be another shortage anytime soon. |
Originally Posted by TNTUBA
(Post 1293708)
The plant in Australia shutting down was the cause of the inventory issues.
When I spoke with the ACL USA folks at PRI I was told there is no reason to believe there will be another shortage anytime soon.
Originally Posted by Laranzu
(Post 1293703)
Literally days after I ordered the Kings. Either way I'm sure they work great.
On that same note, King is not the best when it comes to inventory management themselves. We've seen a number of shortages in the past few months. |
Orders shipped - another 50 sets arrived in this mornings mail. Tracking issued.
|
If I have understood correctly ACL went broke a number of years ago, but ran under administrators for long a time while a buyer was sought. Hence the spotty supply.
ACL USA have purchased some of the machines and taken on some of the staff, to make a selected range. Supply should be ok from now. |
Originally Posted by FAB
(Post 1293803)
If you ordered them form us I don't mind swapping them out. However based on the quality control, precision measurement system used and a harder material (great for the forged BP cranks) used by King I feel they are a better tri-metal bearing than the ACL but the internet is responsible for the current preference in the BP community. Either way you won't have problems with each bearings.
I'm sure they are great. Its just that I waited months to order internals because no bearings were around. Then I found you guys had the Kings. So I'm still stoked to use them! |
All times are GMT -4. The time now is 07:22 PM. |
© 2024 MH Sub I, LLC dba Internet Brands