Dow.tom

iTrader: (3)

So MD emissions i fails

Hydrocarbons
220PPM Limit
615PPM Mine

Carbon Mono
1.20PCT Limit
7.98PCT Mine



I think this is all due to Megasuirt. To get the to settle i dumped fuel in and i think because of that is why i failed.

I dont have a wideband so im not sure of my ratio, any ideas or tips to lower these two?
thanks

MX5-4me

bite the bullet and get a Wideband. Without one you are risking leaning it out too much and blowing your engine. they aren't that expensive.

Dow.tom

iTrader: (3)

i have a wideband, but i cant get the old sensor out of the bung... I do not have a turbo on at the moment. i guess i'll see if the shop can get it out.

Dow.tom

iTrader: (3)

okay so monday they will remove my 02 sensor and replace it with the wideband.

y8s

iTrader: (8)

heat up the pipe around the bung with a propane torch but dont get the sensor hot and then try getting it out.

Ben

iTrader: (33)

You're too rich. Lean it out some. A narrowband is perfect for tuning for emissions since you're going for stoich or just a tad lean of stoich, right in the range a narrowband is specifically designed to work in.

Joe Perez

iTrader: (8)

Don't put the WB sensor in the stock location- it'll overheat. You need to install a second bung on the downpipe about a foot before the catalytic converter.

But yeah, Ben is right. Tuning for emissions at light load is exactly what NB sensor are for. When you get it to the point where it's ticking back and forth across 0.5v with some regularity, you're there.

Dow.tom

iTrader: (3)

can i do this in MEGAsquirt? or do i have to buy a NB?

Dow.tom

iTrader: (3)

okay i decided to start from scratch with the base map. I got it to idle now at 54% as opposed to the pig rich 80% haha. So hopefully that will lower my hydrocarbons and carbon mono. Any other tips? Should i take a datalog and post it up here?

Dow.tom

iTrader: (3)

well after lowering the %'s it now rides smoother than before, i dont get studding when lifting or accelerating. Is it worth it to go back fro my free emissions now or wait till april when i have my turbo on

fmowry

iTrader: (8)

Get a receipt for your O2 sensor replacement labor when you take it to the shop. Get a receipt for your WBO2, that is within 30 or 45 days of the emissions test. If the total for the "emissions based repairs" are over $400 total you can get a waiver for emissions at the DOT.

Frank

Braineack

iTrader: (62)

Damn Tom, were you even getting 5mpg?!

Dow.tom

iTrader: (3)

prob not Scott, but i never noticed cause i dont drive it too much... By installing MSPnP to lower my fuel ratio does that count towards the 400 dollars frank, cause it cost me 700