apexi/greddy bov flange
 

Does anyone know if the flange for an apexi bov is the same as that of a greddy bov flange? Or, can anyone who has a greddy bov/flange measure it for me? Trying to see if I can use one of the prefabbed flanges or if I have to just fab my own.

I don't think they will work... I have a GReddy flange and two BOV's (Type-S and Type-R) at home. What exactly do you need measurements from? Mounting hole to mounting hole? If I remember tonight I will take some measurements for you.

If you can get me the following...

- mounting hole to mounting hole
inner diameter
min width between the inner diameter and the side of the flange

I'd appreciate it.

Sorry man... I've been out of town until today. I will try to get this measured up for you tonight and post up the results in the morning. Should include all possible measurements for you...

Is that for mad tyte vtek spool?

^ Werd....

That'd be great, thanks!

Took the measurements already... Just don't have the image to post the measurements I took on this computer. I will have them posted up in pic format tomorrow for ya.

Here you go... From these measurements you pretty much calculate anything you need. Hope it helps...

thanks so much I really appreciate it. I'll let you know if they work tonight

Not a problem at all man... Glad I could help out.

Any chance to check fitment?

it's close, but to make it work it'd be almost as much work as fabbing my own mount, so I ended up just fabbing my own up. Thanks again, I really appreciated it.

Not a problem man. Glad I could be of assistance.