Building a new harness
 

I've been looking for over a week now on Miata-specific information on building a new wiring harness and going in and replacing all the wiring in the Miata, as my wiring harness is starting to piss me off.

Catch is, I haven't been able to find much on it via searching google, here, or the other Miata sites. I've already built a harness from scratch for my RX7 - are there any pitfalls I need to worry about with the Miata? Or is it very straightforward to build a Megasquirt-based harness, replacing all the sensors for GM-equivalents?

Also, on a sidenote, where do people recommend mounting the Megasquirt? I'm adverse to my stock mounting location (Early NA), as it had a fair bit of rust there that was a pain in the ass to remove, and the glovebox is not where I want to mount it long-term. Behind the passenger seat seems to be a popular choice, but assuming there is no restrictions on mounting, is there a better option? Hell, I can put it in the trunk without issue if that's desirable.

(Edit) Got a link to FRT_Fun's thoroughly awesome writeup from a kind forum member, thanks guys!
(Edit2) Boo, his writeup is incomplete.

On top/side of the tranny tunnel, behind dash? Also, be sure not to post the link to said incomplete write-up.

I'm planning to replace everything in the car atm, Oscar. Done with trying to figure out what the hell half a dozen different owners did.

Writeup: http://www.miataforumz.com/showthread.php?t=295