halfshaft question
05-18-2007, 01:52 AM
#1
Junior Member
Thread Starter
iTrader: (9)
Join Date: Apr 2007
Location: Hanover, MA
Posts: 237
Total Cats: 0
halfshaft question
I'm really trying to cheap out on my build and was curious if i could disassemble an 89-91 RX7 halfshaft and use the splined end off my 1991 Halfshaft? Would this end up being the same length of the 95+ shafts?
Reply
0
0
05-18-2007, 08:41 AM
#2
Boost Czar
iTrader: (62)
Join Date: May 2005
Location: Chantilly, VA
Posts: 79,483
Total Cats: 4,076
I used the 1.6L hub-ends on my 1.8L halfshafts,
but yes it should work since:
"the 86-91 NA RX-7 halfshaft is similar to the 94+ Miata halfshaft with the same ~25.25" length and the same 94/95 Miata stub shaft bolt pattern of 4x110 but it uses a larger hub shaft diameter of 28 spline by 29mm"
but yes it should work since:
"the 86-91 NA RX-7 halfshaft is similar to the 94+ Miata halfshaft with the same ~25.25" length and the same 94/95 Miata stub shaft bolt pattern of 4x110 but it uses a larger hub shaft diameter of 28 spline by 29mm"
Reply
0
0
Thread
Thread Starter
Forum
Replies
Last Post
bigmackloud
Miata parts for sale/trade
19
01-08-2021 11:24 AM
JesseTheNoob
DIY Turbo Discussion
15
09-30-2015 02:44 PM
