How much will this engine take?
Found a used engine that I am seriously looking to purchase. Here's the specs as far as the guy selling it knows:
Has just over 10000 miles on it Was built by FM and cost just over $5000 when it was bought WisecoPistons, forged; 9.0:1CR 1mm overbore Carrillo Rods, Set/4 (A beam) ARP head studs ARP main cap studs ASF engine prep work, custom ASF multi-angle valve job and prep/assembly ASF unshroud valves ASF backcut stock intak valves Powdercoated valve cover black That's all the guy knows about it. Would this engine hold together upwards of 350+ horsepower? If so, how much past? I can save quite a bit of money going this route so it's something I'm seriously considering. |
that will take literally anything you plan on throwing at it.
with a good tune. On a side note, I would verify with FM what is in the motor, etc... Don't take the guys word for it. |
that engine can handle more power than the chassis or you...
|
The short answer to your question is yes.
The longer answer is with that engine everything else in the potential drivetrain basically says screw off...I don't want to work that hard. |
Somewhere north of 500whp.
|
How long it can take it is the real question. It will handle any hp number you throw at it. Unfortunately people equate "built" motors with longevity. That's just not the case.
Frank |
I know plenty of people with 60k+ miles on built motors. How many years is that for you?
|
Well, with the setup in my signature on this engine I hope to break 400hp on race gas and sit comfortably at just over 325hp using pump gas for street use. My car is an 01 with less than 20000 miles on it, so I don't really rack up the miles, but I'm pretty hard on the car when I do.
|
You should be able to get 400whp on pump gas. I did.
|
I just had it dropped off and I'm very happy. Got the engine, a 6 speed transmission and a trunk lid for $2000 delivered to my garage.
|
Wow, nice score!!!
I hope it all works out for you. |
Originally Posted by Savington
(Post 298166)
Somewhere north of 500whp.
|
motec exhausts?
|
Originally Posted by JayMX5
(Post 298282)
I just had it dropped off and I'm very happy. Got the engine, a 6 speed transmission and a trunk lid for $2000 delivered to my garage.
|
Originally Posted by cardriverx
(Post 298403)
Hell of a deal. Be sure to post when you dyno it!
|
Wish I had one!
|
my question is how much can a stock motor handle with boost?, turbo or supercharger
|
Mine took 15psi on a stock motor,no intercooler,factory timing with 100 octane.Way rich on fuel...for a short time.
Then it was off to that big engine stand in the sky!!! |
All times are GMT -4. The time now is 09:11 PM. |
© 2024 MH Sub I, LLC dba Internet Brands