LC-1 delay
09-29-2008, 05:27 PM
#1
Slowest Progress Ever
Thread Starter
iTrader: (26)
Join Date: Oct 2007
Location: The coal ridden hills of Pennsylvania
Posts: 6,022
Total Cats: 304
LC-1 delay
So I've had my LC-1 with the G3 gauge on my car for about 9 months now, and I always noticed that when I start the car, the gauge reads all the way rich for a while, and then it moves up to where it should be. I assume this is a delay period for the heater? I just wondered, cause now my LC-1 is hooked to my MS and if it does this delay on start-up...then the MS won't be reading O2 signal till the O2 sensor heats up right?
Reply
0
0
09-29-2008, 05:32 PM
#2
Elite Member
iTrader: (11)
Join Date: Jun 2007
Location: Overland Park, Kansas
Posts: 5,360
Total Cats: 43
Approx 30 seconds after startup is the warmup time for the sensor, where it'll read rich or lean (mine reads like 7:1 rich...) then it goes normal. Thats typical.
If you hook your computer up to the LC-1 and open the LM Log Viewer, it'll indicate the warmup percentage while your gauge shows rich.
If you hook your computer up to the LC-1 and open the LM Log Viewer, it'll indicate the warmup percentage while your gauge shows rich.
Reply
0
0
Thread
Thread Starter
Forum
Replies
Last Post
