LC-1 delay
So I've had my LC-1 with the G3 gauge on my car for about 9 months now, and I always noticed that when I start the car, the gauge reads all the way rich for a while, and then it moves up to where it should be. I assume this is a delay period for the heater? I just wondered, cause now my LC-1 is hooked to my MS and if it does this delay on start-up...then the MS won't be reading O2 signal till the O2 sensor heats up right?
|
Approx 30 seconds after startup is the warmup time for the sensor, where it'll read rich or lean (mine reads like 7:1 rich...) then it goes normal. Thats typical.
If you hook your computer up to the LC-1 and open the LM Log Viewer, it'll indicate the warmup percentage while your gauge shows rich. |
All times are GMT -4. The time now is 05:47 PM. |
© 2024 MH Sub I, LLC dba Internet Brands