MX_Eva

As I have a new custom intake manifold coming my way I was wondering if anyone knew what size plug is needed on the block for the line that runs to the intake manifold. I know it was brought up recently in "stuff I can remove now that I have MS" was the jist of the thread (included silly stuff that you can remove pre-ms like charcoal canister etc) i just can't seem to fin the thread.

hustler

iTrader: (6)

in for answer.

Braineack

iTrader: (62)

5/16"

akaryrye

iTrader: (5)

If it was me i would go ghetto and just use a short piece of hose with a screw/bolt in it. It will work just fine, if not better than any plug you could buy. Ive seen enough plugs/caps for stuff like that crack at the ends.

How the hell do you know stuff like that scott? Guess thats why your called braineack

Braineack

iTrader: (62)

cause i blocked all the coolant lines to my TB.

Joe Perez

iTrader: (8)

Most of the little water fittings under the hood are 8mm, such as the one from the mixing manifold to the thermostat housing, the block to intake, etc. I have typically used 5/16" fuel hose for them- works out to 7.9mm. I'd expect that a 5/16" cap with an appropriate clamp would do the trick.

levnubhin

iTrader: (30)

Brain, did you block the coolant to the manifold also?
__________________
Best Car Insurance | Auto Protection Today | FREE Trade-In Quote