Miata Turbo Forum - Boost cars, acquire cats.

Miata Turbo Forum - Boost cars, acquire cats. (https://www.miataturbo.net/)
-   General Miata Chat (https://www.miataturbo.net/general-miata-chat-9/)
-   -   Leaking something? (https://www.miataturbo.net/general-miata-chat-9/leaking-something-93688/)

sshamrockk 06-21-2017 07:54 PM

Leaking something?
 
So about 2-3 weeks ago I replaced my clutch and flywheel, while in there I replaced the front trans seals and the rear main seal. Now I have a leak that developed last week. Can't tell if it's gear oil or engine oil. I did forget to install a drain plug washer in the trans, but it doesn't seem to be leaking from there, the entire bottom of the bell housing is wet, as well as the front half of the trans. Last summer I also replaced the Cas seal, valve cover gasket, front main seal, and cam seals. Now I'm starting to worry its leaking from inside the bell housing. Sometimes when I accelerate hard through a couple gears I get a with of something burning, I fear it's my clutch from oil soak.. The car is naturally aspirated Btw. What should I do next? I'm going to reinstall the drain plug washer tomorrow and hope for the best..

concealer404 06-21-2017 08:07 PM

Probably rear main again.

sshamrockk 06-21-2017 09:13 PM

I know, but I hope its not.. pulling the trans again doesnt sound fun, it took me collectively about 16 hours to do the clutch. Has anyone paid to have their clutch/ rear main seal replaced?

concealer404 06-21-2017 09:28 PM

Rusty car?

sshamrockk 06-21-2017 09:52 PM

Nah, its a 94 was always garage kept, no rust. Just did everything by my self, work slow. I'm sure I could do it in one day now the second time around if it came to that, but I might just let a shop take over for that..

sshamrockk 07-05-2017 07:51 AM

Just an update, car is still leaking, I'v identified it as gear oil from the trans, by the smell. I put my turbo kit in this weekend, and even on a base map and only 7psi the clutch is slipping. So it's soaked in oil, I'll order and new friction disk, the flywheel and pressure plate should still be alright to reuse, correct? They are almost new, about 2k miles on them.

ryansmoneypit 07-05-2017 08:11 AM

What clutch did you install? I only use oem Mazda seals in critical areas, like a rear main.

sshamrockk 07-05-2017 09:29 AM

Flying Miata level one happy meal. 13lb flywheel. And got seals from flying Miata, they are genuine Mazda seals. I either forgot to install the seal in the input shaft of the trans, or installed it wrong. Won't know till I drop it. Ordering up a new clutch disk and all new seals again tonight so I don't have to wait after trans is dropped.


All times are GMT -4. The time now is 12:02 AM.


© 2024 MH Sub I, LLC dba Internet Brands