Loud grinding/rumbling/vibration on full boost / high rpm
Afternoon all,
Another day, another problem, recently finished my turbo conversion on my 1.8 93 enous. This problem all started after I had the car mapped. When I put my foot down and accelerate hard, from about 5k revs onwards and at high speeds I am getting a very rough grinding/vibration but I cannot put my finger on it, the noise goes away if I put my foot on the clutch, lift up and it comes straight back. Absolutely no noise under 70 mph or cruising a low revs. When doing the conversion the engine was out, changed the clutch to an XTD stage 2 with a new clutch release bearing. Ideas anyone? Cheers |
Forgot to add, had the car up and cannot notice anything obvious rubbing anywhere
|
Id start with seeing if the exhaust is contacting the chassis when the drivetrain is torqued over under load. Start with the simple stuff first.
|
I was going to guess motor mounts allowing something to contact.
|
Originally Posted by sixshooter
(Post 1351390)
I was going to guess motor mounts allowing something to contact.
im going to have another look tomorrow however before I read this I noticed the rear baffle on the straight (before the backbox) is touching a chassis bar but I didn't see any obvious marks on the exhaust or chassis, I will try moving it or wedging some rubber in there tomorrow and see if it eliminates the problem |
All times are GMT -4. The time now is 07:30 AM. |
© 2024 MH Sub I, LLC dba Internet Brands