Oil temp sending unit mounting
So I had mounted my oil temp sending unit a few months back. I put a "T" into the block where the oil pressure sending unit is, to run a feed line to supply the turbo. I also put a "T" on top of that "T" and I mounted my oil pressure sending unit there. Do you guys think this is a good place to get an accurate reading? If it's a nice day out (60-70 degrees) and I cruise my car on the open road, it usually runs at 165 degrees? In the 100 degree heat of summer, it never went over 195. I was thinking about relocating the sending unit to my oil pan, but drilling that on the lower sump is a real tight pain in the ass. Think I should leave well enough alone? FVI, my oil supply line to turbo is -4 and it runs to an oil cooler, and then to the turbo.
|
Oops, I fucked up.
Put the sensor in the pan. |
Mine is at the oil cooler sandwich plate but goes from 50C-80C alot. It's going to move to the pan later.
|
Mine is in the pan- consistent readings.
|
I have a relocated plate at the firewall for the pressure, but chose not to use extra "T" for the Temp....
I am looking into using the existing drain plug as a source for tapping a Temp sensor in it. |
Originally Posted by Machismo
(Post 320856)
I have a relocated plate at the firewall for the pressure, but chose not to use extra "T" for the Temp....
I am looking into using the existing drain plug as a source for tapping a Temp sensor in it. |
Originally Posted by Machismo
(Post 320856)
I have a relocated plate at the firewall for the pressure, but chose not to use extra "T" for the Temp....
I am looking into using the existing drain plug as a source for tapping a Temp sensor in it. however, I'd love to get a 1/2"npt-1/4"npt adapter for my greddy egt probe...or just sell it. |
I don't have that kind of muskle powa! ;)
That's why I haven't done it yet.....I've heard of it being done. Just not the "bads" that it can do. Thanks yo! |
Originally Posted by Saml01
(Post 320858)
I believe you can get a ready made drain plug just for that purpose.
|
Originally Posted by Machismo
(Post 320864)
That is exactly what I will be sourcing. ;) Thanks......
|
All times are GMT -4. The time now is 10:43 AM. |
© 2024 MH Sub I, LLC dba Internet Brands