So....6 speed hitting trans tunnel?
I'm slowly getting around to making my 2004 MSM run again and went to install shifter. 4 bolts removed for clearance for install and now the "turret" is hitting the trans tunnel? Don't get it. Using Blackbird Fabworks stock hight motor mounts. Ideas?
https://cimg6.ibsrv.net/gimg/www.mia...55b1ed34c8.jpg https://cimg1.ibsrv.net/gimg/www.mia...bc2d287e4e.jpg https://cimg5.ibsrv.net/gimg/www.mia...15f6b23661.jpg |
Check your PPF angle.
|
I would think PPF angle is off too.
|
Originally Posted by concealer404
(Post 1568983)
Check your PPF angle.
|
|
Yeah, use that. Only issue is if your frame rails are crushed.
|
So with all ppf bolts loose I can get it to 70mm. If I hang on it while I tighten it best I can get is 77mm. Now what. I got no idea.
|
Originally Posted by IcantDo55
(Post 1569464)
So with all ppf bolts loose I can get it to 70mm. If I hang on it while I tighten it best I can get is 77mm. Now what. I got no idea.
|
Double post
|
Most likely the BF mounts. Are the coils or a reroute hitting the fire wall? Ground strap or wiring? 70mm is good and 77 may cause a driveline vibration.
Originally Posted by IcantDo55
(Post 1569464)
So with all ppf bolts loose I can get it to 70mm. If I hang on it while I tighten it best I can get is 77mm. Now what. I got no idea.
|
All times are GMT -4. The time now is 01:00 PM. |
© 2024 MH Sub I, LLC dba Internet Brands