M.netters would be pissed
#1
Elite Member
Thread Starter
iTrader: (46)
Join Date: Dec 2007
Location: Nebraska
Posts: 4,729
Total Cats: 166
M.netters would be pissed
Finishing up my wife's 91BRG refurbish. The shift **** was crusty, the finish was chipped and the rubber band around the **** was smooshy and would leave black marks all over your hand.
So, I figured I would strip it and refinish it. None of the solvents that I had would touch the finish. I couldn't do anything with the rubber band to save it. The Nardi logo was kind of hosed up anyway. I'm sure the purists would say to just leave it alone and keep it original, but it looked like crap.
So, I sanded the whole thing, including, GASP!, the logo. I couldn't figure out what to do with the 1/8" deep groove where the rubber band was. Finally, it occurred to me. I'm sure the MT folks will figure it out! I don't think it came out too bad. It needs another coat or two of polyurethane.
So, I figured I would strip it and refinish it. None of the solvents that I had would touch the finish. I couldn't do anything with the rubber band to save it. The Nardi logo was kind of hosed up anyway. I'm sure the purists would say to just leave it alone and keep it original, but it looked like crap.
So, I sanded the whole thing, including, GASP!, the logo. I couldn't figure out what to do with the 1/8" deep groove where the rubber band was. Finally, it occurred to me. I'm sure the MT folks will figure it out! I don't think it came out too bad. It needs another coat or two of polyurethane.
Thread
Thread Starter
Forum
Replies
Last Post