Trying to finish My PnP coil Harness but...
 

I'm trying to finish the coil Harness for my 1.6L and I stuck at the last step. Which diagram to I follow to wire it as a plug and play? I ask because the wire colors and pin locations do not match unless I'm looking at it wrong. They are both supposed to be for a 1.6L. What Gives???
Diagram 1:
http://www.boostedmiata.com/FAQ/cops..._Schematic.jpg

or
Diagram 2:
http://www.boostedmiata.com/FAQ/cops..._explained.jpg

Just for example in the D1 it says the Brown/yellow is the trigger for coil 1 & 4 and in D2 the trigger for coil 1 & 4 is listed as a thick blue wire.

Fail

Ignore the text on "diagram 2"

That what I eventually did, Thanks Ben. COPS Working Great.

Sweet, mine do too. I've got a .045" gap which doesn't blow out up to 17 psi or so. Haven't tested further with my little turbo and stock motor.

Going to open the gap first thing in the morning. Then i suspect i will be getting the most out of the cop setup.

Replying to one of your threads so you quit pissing and moaning to Paul trying to find a father figure.
Check the gap in your vagina while you're at it.