Bryce

iTrader: (24)

I was pondering why my car seemed to be low on power compared to the other greddys at the same boost level (15psi) and realized my Tony DP had been modified with 2 crush bends.

Any idea how much power and spool this is sapping me of? I died a little when I took these pictures. I'm also wondering what a reasonable price would be if I took the DP to a shop and had them weld in mandrel bends.

bryantaylor

iTrader: (5)

i really doubt that is going to make a difference. and why is your trans covered in oil?

KPLAFIN

iTrader: (1)

+1 I'd be more worried about the oil than those two little bends, they probably aren't hurting you much if at all.

Bryce

iTrader: (24)

Leaking CAS O-ring.

Then why have I read a mandrel bent 2.5 is better than a crush bent 3?

bryantaylor

iTrader: (5)

butt dyno says it makes no difference at all. it really doesn't matter. these aren't pro level race cars. you will never be able to feel the 2whp difference it "might" make, so why worry about it?

Braineack

iTrader: (62)

those dont even look like crush bends. just bad mandrel ones.

paul

iTrader: (21)

bad crush bends that you have to worry about look like accordions on the inside of the bend.

Bryce

iTrader: (24)

Right then. I'm off to find other things to blame.

UrbanSoot

iTrader: (24)

y8s

iTrader: (8)

they're crush but they're not accordion

jayc72

iTrader: (14)

That doesn't look like the DP I had made by Tony. Don't remember the welds looking as shitty or any three bolt flanges.

Bryce

iTrader: (24)

Got it from Keinayo, who got it from M2cupcar I think. I don't know why it was modified.

patsmx5

iTrader: (16)

I'd have a shop weld in some mandrel bends. + 2.245 HP FTMFW.

hustler

iTrader: (6)

I could never find my oil leak...then i pulled the motor and realized the headgasket was leaking like..um...I can't really compare this unreplicated leakage level.

Bryce

iTrader: (24)

Maybe that's where all my ponies are going.

Gosh guys yall make me wanna go wipe the tranny with a rag.

patsmx5

iTrader: (16)

Yeah you're gonna wanna fix that oil leak.

Toddcod

iTrader: (8)

My 3 inch exaust has the crappy bends. But hey it is 3inch exaust cheap. And Im sure it flows better than a smaller pipe. I'm not trying to be a top fuel dragster. Seat of the pants O'meter is what matters. I wouldn't spend the money on the switch.

But life is short. Do what makes you Happy.

Bryce

iTrader: (24)

No thanks, they can stay if it's that small a difference. Just trying to figure out what's holding me up.

turbobluemiata

iTrader: (8)

my transmission kinda looks like that

hustler

iTrader: (6)

why use a rag when you can use the chinese flag?